![]() I don't have a manual to share but I've had my Speedio for just over 1 week and it's already mostly second nature. make sure your tools and depths are set correctly. Tapping cycles are usually over before you even have a chance to blink, so. As soon as it rapids to position it goes in at 100%. Tapping cycles are so fast that your tools better be set up right, and for some reason the control does not stop at the feed plane if your Feed is set to 0. You need to be SURE it's installed into the magazine holder correctly, you can see this if you peak under the tool and see the wide key that inserts into the drive slot of the toolholder. It is really easy to think you did it right but to have not aligned the key and seated it all the way. Make sure you know how to install the tools correctly. ![]() The three things that come to mind that could immediately be an issue for a new user are: I don't set rapids to 5 unless the program has been well proven
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |